0
Skip to Content
Rigging & Heavy Lifting Equipment Supplier
ABOUT
PRODUCTS
Lifting Slings
Wire Rope
Rigging Hardware
Rope & Rope Inspection
Cranes
Winches
Hoists
Wire Rope Fittings
Spreader Beams
Chain
Crane Blocks & Sheaves
Load Measurement
Parking Garage/Hand Rail Installs
SERVICES
PARTNERS
CAREERS
CONTACT
LOCATIONS
1-800-40-SLING
Rigging & Heavy Lifting Equipment Supplier
ABOUT
PRODUCTS
Lifting Slings
Wire Rope
Rigging Hardware
Rope & Rope Inspection
Cranes
Winches
Hoists
Wire Rope Fittings
Spreader Beams
Chain
Crane Blocks & Sheaves
Load Measurement
Parking Garage/Hand Rail Installs
SERVICES
PARTNERS
CAREERS
CONTACT
LOCATIONS
1-800-40-SLING
ABOUT
Folder: PRODUCTS
Back
Lifting Slings
Wire Rope
Rigging Hardware
Rope & Rope Inspection
Cranes
Winches
Hoists
Wire Rope Fittings
Spreader Beams
Chain
Crane Blocks & Sheaves
Load Measurement
Parking Garage/Hand Rail Installs
SERVICES
PARTNERS
CAREERS
CONTACT
LOCATIONS
1-800-40-SLING
Spreader Beams Modulift drop links
Modulift drop link Image 1 of
Modulift drop link
Modulift drop link

Modulift drop links

$0.00

Having the separate drop link means that any misalignment +/- 6 degrees of the bottom slings (i.e. if they are not vertical because the span of the spreader is longer or shorter than the distance between the lifting points on the load being lifted) will not induce bending into the Modulift spreader, unlike the fixed end design.

Therefore, the Modulift spreader design is like a ‘pin-ended strut,’ and all the load transferred from the slings to the spreader is purely axial.

This means that, like-for-like, Modulift spreaders are much lighter when comparing similar capacity beams.

Quantity:
Add To Cart

Having the separate drop link means that any misalignment +/- 6 degrees of the bottom slings (i.e. if they are not vertical because the span of the spreader is longer or shorter than the distance between the lifting points on the load being lifted) will not induce bending into the Modulift spreader, unlike the fixed end design.

Therefore, the Modulift spreader design is like a ‘pin-ended strut,’ and all the load transferred from the slings to the spreader is purely axial.

This means that, like-for-like, Modulift spreaders are much lighter when comparing similar capacity beams.

Having the separate drop link means that any misalignment +/- 6 degrees of the bottom slings (i.e. if they are not vertical because the span of the spreader is longer or shorter than the distance between the lifting points on the load being lifted) will not induce bending into the Modulift spreader, unlike the fixed end design.

Therefore, the Modulift spreader design is like a ‘pin-ended strut,’ and all the load transferred from the slings to the spreader is purely axial.

This means that, like-for-like, Modulift spreaders are much lighter when comparing similar capacity beams.

 

American Rigging | Cal Swage | Cableco | Carpenter Rigging | Cable Cisco |
Carpenter Group Hayward Cable Moore | Consolidated Rigging

© 2025 - The Carpenter Group® | Privacy Policy | Warnings/Prop 65